How To Install a Bamboo Wall

a couple of hours, depending on how many walls your covering
Bring Home the Tropics

 

Image removed.

Why continue to live with a cold, gray stone wall when you can easily spruce it up with a bit of bamboo? A simple and inexpensive task, this project involves covering your wall with a warm and inviting bamboo wall treatment (sometimes referred to as Bamboo Fencing) that can be found at any home improvement center. Bringing the romance of the south seas into your patio is easier than you think!

This one-day project will welcome guests into your yard and call to mind exotic places!

Although it's not very expensive you'll want to be sure to measure your walls accurately and buy enough to have a bit left over; you may find a novel use for it like we did.

Want to see this project in action? Check out our Stretch out your Summer Series.

Project Steps

Step 1

 

bamboostep1

Start by drilling holes into the wall. Place the holes approximately 1' to 2' apart, alternating holes from the top of the wall to the bottom. (Making a vertical zigzag formation). Since we were putting anchors in masonry, we used a masonry bit.

Jane Tip: Attaching the bamboo in many places will make the finished product look better as well as making it sturdier!

Step 2

Place anchors inside holes, giving them a tap with the hammer to secure them into place. Next, position the screws inside the anchors. Turn the screw almost all the way in, leaving a little room between the screw and the anchor to wrap the wire around.

Step 3

bamboo3 

Using wire cutters, cut 6" pieces of wire to go around the screws. They don't have to be exactly 6", just make sure the wire is long enough to wrap around the screw a few times as well as the bamboo.

Step 4

Wrap the wire firmly around the screws in the wall.

Step 5

Place the bamboo roll against the wall, making sure it is positioned exactly where you want it.

Jane Tip: Have a friend help you out with rolling the bamboo out and securing it to the wall. One person can hold the bamboo roll, while the other tends to the wire.

Step 6

bamboo6bamboo step62

With one person holding the bamboo roll against the wall, find the first piece of wire that you attached to the wall. Push the wire through the bamboo from the back to the front, securing it against the wall by twisting the wire like a twist-tie.

Step 7

Once you have fastened the wire, hide the excess wire by tucking it behind the fencing.

Step 8

Continue to roll the bamboo out towards your next fastening point. To ensure a neat-looking wall, pull the bamboo taut as you roll it out. Take your time and make sure the fencing is straight and flush against the wall.

Step 9

Attach the wire to the bamboo, as in Step 6. Hide excess wire as described in Step 7.

Step 10

Repeat steps 6 through 8 until you have fastened all of the wires to the bamboo.

Step 11

bamboostep11 

You may have excess bamboo when you come to the end of your wall. Cut away any left over fencing with garden shears.

Jane Tip: If your bamboo is extra thick, you may want to measure it out against the wall first and then cut it with a circular saw. The garden shears may be too weak to cut through the fencing.

Be creative with any excess bamboo fencing. We used ours to accent light fixtures.

Now you are armed with everything you need to know to give your backyard the lift it needs! Don't be afraid to bring a taste of the tropics to your outdoor living space.

Related articles:
How to Install Outdoor Speakers
Create an Outdoor Living Room
Extend your Summer with Outdoor Heaters